Toshiba e-studio206l Troubleshooting Manual page 38

1 TROUBLESHOOTING FOR THE HARDWARE
6
Turn the knob shown in the following figures to send the paper, and then remove the
jammed paper.
When the Hole Punch Unit is installed, open the front cover of the finisher and turn the 2 knobs at the same
time.
When the Hole Punch Unit is not installed
Some jammed paper may get inside of the Saddle Stitch unit depending on the location where the jamming occurs.
In this case, follow step 7.
7
Close the upper receiving tray of the finisher.
Place your hands on the near and far side of the lever and push to
close the tray until it clicks.
Be careful not to let your fingers be caught between the
finisher body and the upper tray of the finisher.
This could injure you.
The upper receiving tray of the finisher can also be closed by
pressing the right side of the lever.
8
Turn the green knob to lower the paper until it is
hidden.
36 Clearing a Paper Jam
When the Hole Punch Unit is installed