Using Recording Timer - JVC MX-J333VU Instructions Manual

7
Press 4 ; or ¢ ; to set the
volume level.
• You can select the volume level from among four
levels. If you select " VOL – – –," the volume is set to the last
level when the unit has been turned off.
DAILY
8
Press SET k to complete the Daily Timer
setting.
The DAILY indicator stops flashing and remains lit.
The setting you have done are shown on the display in sequence.
9
2 , ! to turn off the unit
Press
(on standby) if you have set the Daily
Timer with the unit turned on.
To turn on or off Daily Timer after its setting is done
1. Press TIMER/CLOCK h repeatedly until "DAILY"
appears on the display.
2. To turn off the Daily Timer, press CANCEL /.
The DAILY indicator goes off from the display.
The Daily Timer is cancelled, but the setting for the
Daily Timer remains in memory.
To turn on the Daily Timer, press SET k.
The DAILY indicator lights up on the display.
The setting you have done are shown on the display in
sequence for your confirmation.
If the unit is turned on when the timer-on timer
comes
Daily Timer does not work.
EN22-29;MX-J333V/PM6
PRESET
NEXT
PREV
SET
STANDBY
TIMER
/CLOCK
DEMO
CANCEL
SET
23

Using Recording Timer

With Recording Timer, you can make a tape of a radio broadcast
automatically.
How Recording Timer actually works
The unit automatically turns on, tunes into the specified station,
sets the volume level to "0," and starts recording when the on-time
comes (the b indicator flashes just before the on-time, and continues
flashing while the timer is operating). Then, when the off-time comes
("OFF" appears just before the off-time), the unit automatically turns
off (stands by).
The timer setting remains in memory until you change it.
• There is a time limit in doing the following steps. If the setting is
cancelled before you finish, start from step 1 again.
• If you have made a mistake while setting the timer, press CANCEL
/. (However, this does not always work. If CANCEL does not
work, press TIMER/CLOCK h repeatedly and start from step 1
again.)
On the unit On the unit ONLY : :
1
Put a recordable cassette into deck B i.
2
Press TIMER/CLOCK h until "REC"
appears on the display.
The REC indicator also starts flashing on the display.
S.MODE
REC
• Each time you press the button, the timer setting modes change
as follows:
DAILY ON TIME
Cancelled Clock
setting
The hour digit starts flashing
3
Press TIMER/CLOCK h again.
"ON TIME" appears for 2 seconds, then the unit
enters on-time setting mode.
S.MODE
REC
REC
23
6/30/99, 2:24 PM
TIMER
/CLOCK
REC
ON TIME
TIMER
/CLOCK
Continued