Pioneer DV-626D Service Manual page 91

Rear Panel (WY and WV types)
1 2
AV CONNECTOR
DIGITAL OUT
OPT.
CONTROL
TV SYSTEM
OUT IN
PAL
NTSC
9 8
1
CONTROL jacks
Use to connect this player to another component bearing the
Pioneer Î mark. This lets you control this unit as though it
were a component in a system. Player operations are then
performed by pointing the remote control at the component that
the player is connected to.
2
AV CONNECTOR jack
Use a 21-pin SCART cable to connect to a TV or monitor
compatible with this type of connection. Both audio (2 channel
stereo) and video (Video, S-video, and RGB) signals are output
from the AV CONNECTOR jack.
3
VIDEO OUT jacks
Connect to the video input on a TV or monitor or AV amplifier or
receiver with video input capability.
4
S-VIDEO OUT jacks
If your TV or monitor has an S-video input, clear picture
reproduction is possible by connecting the player to your TV or
monitor via the S-video jack.
5
AUDIO OUT (2 ch) jacks
Use to output two-channel audio (analog) to the audio stereo
inputs on a TV or stereo amplifier. If you are connecting to a
receiver that has both digital and analog input jacks for DVD
player connection, it may be beneficial to make both
connections.
6
AUDIO OUT (5.1 ch) jacks
Use to output 6 discrete audio channels of decoded digital
audio to a receiver or amplifier with discrete audio inputs.
3 4
S-VIDEO
OUT
VIDEO OUT
1
1
AUTO
2
2
5 6
AUDIO OUT (2 ch) AUDIO OUT (5.1 ch)
CENTER
L
L
R
R
SUB
1 2 FRONT SURROUND
WOOFER
7
AC IN power cord connection terminal
Use to connect the power cord to the wall outlet .
8
TV SYSTEM switch
Use to change the TV signal mode to either PAL or NTSC
according to the type of TV and disc to be used. When the
switch is in the AUTO position, the player outputs the format on
the disc as is.
9
DIGITAL OUT jacks (coaxial, optical (OPT.))
Use to output the digital audio signal recorded on discs. You
can output the digital signal via either coaxial or optical output
jack to an AV amplifier or receiver.
DV-626D
7
AC IN
91