Motorola SB5101 Reference Manual page 32

Displays VxWorks host name table
hosts
Displays a summary of each task and associated TCB (Task Control Block)
I
Display information about all attached network interfaces
ifconfig
Displays information about specific interface
ifconfig [interface]
Displays IP filter cache information
ipcache
Displays IP filter cache statistics
ifcachestat
Displays state of IP filters
ipfilter
Displays Engineering symbols whose values are near a specified value
lkAddr [addr]
Displays LLC filter information
llcfilter
Displays MAC packet counts and statistics
macstat
Displays system memory partition blocks and statistics
memShow
Displays multicast protocol information
multicast
Displays statistics for all protocols
netstat
Displays statistics for ICMP
netstat –icmp
Displays IP statistics
netstat –ip
Displays all active connections for IP sockets
netstat –inet
Displays routing tables
netstat –rn
Displays statistics for the TCP protocol
netstat –tcp
Displays statistics for the UDP protocol
netstat –udp
Ping an IP address
ping <x.x.x.x>
Ping an IP host by name (names are only configurable at the Engineering
ping <hostname>
Diagnostic Level)
Exits the login session
quit
Reset the Cable Modem
reset
rlogin <hostname> Establishes a rlogin session to hostname (names are only configurable at
the Engineering Diagnostic Level)
Displays host and network routing table
routes
Sets some debug flags (see below)
setdbg
Displays startup log information
startuplog
Establishes a telnet session
telnet <x.x.x.x>
Displays TFTP information
tftpinfo
Displays upstream diagnostic information, (SID, power level, frequency,
usdiag
rate)
Displays software/hardware versions
ver
10.1.5 Key Debug Flags:
<Set through CLI setdbg command>
<By default, they are set to 0, except QAM 16 Preamble is set to 1>
Ignore Auto Update IF 1, Do not auto update the Firmware image upon registration
IF 0, Auto update the Firmware image as designated by TFTP Config file
Canned Registration IF 1, DHCP, TOD, TFTP will be bypassed and canned registration will be
used
IF 1, Do fine scan
Fine Scan on
Use Scan Limit
DHCP Debug On
Confg Debug On
TOD Debug On
MOTOROLA BCS
IF 1, Perform scan within parameters of the defined scan limits
IF 1, DHCP Debug statements are displayed
IF 1, Config Debug statements are displayed
IF 1, Time of Day Debug statements are displayed
CONFIDENTIAL
SB5101 Cable Modem Overview
Page 32 of 34