Makita DCS3500 Repair Manual page 18

07 IGNITION SYSTEM
13
12
11
10
9
Removing the ignition armature
Remove cover and air filter.
Unsrew screws 2 and 12.
Pull fuel lines 6 from the primer.
Push detent 7 on the primer 8 slightly and pull
out the primer.
Disengage short-circuit wire 10 from the
rocker 11 and pull the rocker up and out.
Unscrew screws 5 and 9.
Unscrew screw 4.
Pull off spark-plug cap 3 and unscrew spark
plug.
Push the spark-plug cap wire grommet out
towards the spark.plug hole.
The cover 1 can now be taken up and off.
Reparaturanleitung PS-4600 / PS-5000
Repair manual DCS3500 / DCS3501 / DCS4300 / DCS4301 / EA3500F / EA3501F / EA4300F / EA4301F / MEA3500L / MEA3500M / MEA4300G / MEA4300L
1
15
2
14
3
4
5
6
7
8
Pull short-circuit wire 15.
Unscrew 2 screws on ignition armature 14.
Remove ignition armature and wire.
16
Installing the ignition armature
Note: The high-voltage cable is moulded onto
the ignition system and cannot be replaced
separately.
Insert the armature and turn the screws in
almost all the way.
Insert the setting gauge 16 (Kapitel 00 Pos. 3)
between the ignition armature and the
fylwheel.
Position the flywheel so that the magnet is
against the armature (gap 0.25 – 0.3 mm).
Press the armature against the gauge towards
the flywheel and tighten the armature screws.
Then check the gap again to make sure it is
correct.
Attach the short-circuit wire 15 and press the
rubber grommet into the carburetor base.
___
18