Makita DCS3500 Repair Manual page 13

04 CLUTCH
Inserting the flyweights
Hook the springs as shown in the illustration.
Then press the flyweights onto the guide. To
do this, first push on two flyweights half-way,
then put on the third flyweight by setting it on
its edge.
Press the flyweights all the way onto the
guide.
CAUTION: Note the position of the springs.
Do not replace springs individually! If a
spring breaks or is fatigued, all three
springs must be replaced. The springs
must not touch the cover.
The illustration shows the inside of the clutch.
Reparaturanleitung PS-4600 / PS-5000
Repair manual DCS3500 / DCS3501 / DCS4300 / DCS4301 / EA3500F / EA3501F / EA4300F / EA4301F / MEA3500L / MEA3500M / MEA4300G / MEA4300L
Installing the clutch
Press the disc onto the clutch. It must be flat
and be engaged.
Installing the clutch
Install the clutch with the arrow marking point
up.
CAUTION:
Before installing the clutch,
disassemble the starter in order to prevent
damage to the starting ratchets
___
13