Using Recording Timer - JVC CA-MXJ100 Instructions Manual

7
When selecting "FM," "MW," or "LW."
Press 4 or ¢ to select the
preset station number, then press
PROGRAM/SET.
The unit enters recording timer
setting mode.
If you want to continue the Recording
Timer setting, go to step 3 of the
Recording Timer setting procedure.
8
Press CLOCK/TIMER.
The indicator stops flashing and remains
lit.
If you have set the Daily Timer with the unit
turned on, turn off the unit.

Using Recording Timer

With Recording Timer, you can make a tape of a radio
broadcast automatically.
How Recording Timer actually works
The unit automatically turns on, tunes into the specified
station, sets the volume level to the preset level and starts
recording when the on-time comes. Then, when the off-time
comes, the unit automatically turns off (stands by).
The timer setting remains in memory until you change it.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
• If you have made a mistake while setting the timer, press
CLOCK/TIMER once and start from step 1 again.
On the unit ONLY:
1
Put a recordable cassette into deck B.
2
Press CLOCK/TIMER until "
REC" appears on the display.
The indicator also starts flashing on the
display.
• Each time you press the button, the timer setting modes
change as follows:
Clock time
REC
PROGRAM/SET
CLOCK/TIMER
CLOCK/TIMER
CLOCK
TIMER
3
Press PROGRAM/SET.
"ON TIME" appears for 2 seconds, then
the unit enters on-time setting mode.
4
Set the on-time you want the unit to turn on.
1) Press 4 or ¢ to set the
hour, then press PROGRAM/
SET.
2) Press 4 or ¢ to set the
minute, then press
PROGRAM/SET.
"OFF TIME" appears for 2 seconds,
then the unit enters off-time setting
mode.
5
Set the off-time you want the unit to turn off
(on standby).
1) Press 4 or ¢ to set the
hour, then press PROGRAM/
SET.
2) Press 4 or ¢ to set the
minute, then press PROGRAM/
SET.
The unit enters the volume setting
mode.
6
Set the volume level when the
unit is turned on.
Press 4 or ¢ to set the
volume, then press PROGRAM/
SET.
The unit enters source selecting mode.
– 17 –
PROGRAM/SET
PROGRAM/SET
PROGRAM/SET
PROGRAM/SET