Items
(M)*
Sensitivity Receiver
Confirmation
(N)*
Timing Confirmation
(O)* RSSI Level Confirmation
(P)* Power RAMP Confirma-
tion
(Q)
Audio Check
(R)
Charging Check
(S)*
TAM Operation
Confirmation
Check
Point
-
Follow steps 1 to 6 of (I).
7.Set DECT tester power to -90dBm.
8.Confirm that the BER is < 1000ppm.
-
Follow steps 1 to 6 of (I).
7.Confirm that the Timing accuracy is < ± 2.0ppm.
-
Follow steps 1 to 6 of (I).
7.Execute the command "readrssi".
8. Confirm that the returned value is 22 ± A (hex).
-
Follow steps 1 to 6 of (I).
7.Confirm that Power RAMP is matching.
-
1. Link with Handset.
2. Input -45dBm/1kHz to MIC of Handset.
Measure the Level at Line I/F and distortion level.
3. Confirm that the level is -8.5dBm ± 2dBm and that the distortion level is < 5%
at TEL Line (600Ω Load).
4. Input -20dBm/1kHz to Line I/F.
Measure the level at Receiver of Handset and distortion level
(*Receive volume set to second position from minimum).
5. Confirm that the level is -21dBm ± 2dBm and that the distortion level is < 5%
at Receiver (Volume Low, 150Ω Load).
-
1. Connect Charge Contact 12Ω/2W resistor between charge+ and charge-.
2. Measure and confirm voltage across the resistor is 3.10V ± 0.2V.
-
1. TAM Confirmation (Execute the command "sendchar_VPI")
2. Confirm the returned Value (Value is "D927FN 03").
Procedure
43
KX-TG9120FXS/KX-TGA910FXS
Check or
Replace Parts
IC7, IC10, L7,
L3, L4, L6,
C117, C118,
C119, C120,
C124, C125,
R106, R109,
DA1, C102,
R102, R103,
Q10, C110,
C112, R111,
C126, C127,
R112
IC7, IC10, L7,
L3, L4, L6,
C117, C118,
C119, C120,
C124, C125,
R106, R109,
DA1, C102,
R102, R103,
Q10, C110,
C112, R111,
C126, C127,
R112
IC7, IC10, L7,
L3, L4, L6,
C117, C118,
C119, C120,
C124, C125,
R106, R109,
DA1, C102,
R102, R103,
Q10, C110,
C112, R111,
C126, C127,
R112
IC7, IC10, L7,
L3, L4, L6,
C117, C118,
C119, C120,
C124, C125,
R106, R109,
DA1, C102,
R102, R103,
Q10, C110,
C112, R111,
C126, C127,
R112
IC7, CN1, SA1,
L1, L2, D3, Q3,
Q4, R14, R15,
R16, R17
R55, R56, C48,
C49
IC8, IC9, R89,
R91, R92