Assembling The Housing; Mounting The Housing To The Wall - JVC WB-1540 Instruction Book

Assembling the Housing

Safety Wire
1.
Desiccant

Mounting the Housing to the wall

Anchor Bolt
(M8, 35 mm and above)
Washer
Safety Wire
1. 2.
Installation Position
Main Housing Unit
Screw A (M4 x 6) x 3
2.
Lower Housing
Position Mark
Gasket
3.
Gasket Gland
Screw B (M4) x 8
Nut
1.
Mount the desiccant
Use a tape to adhere the supplied desiccant to the interior
of the lower housing.
CAUTION:
● Fogging may occur when there are drastic temperature
changes. In this case, continue using without turning off
the power.
● Pay attention when handling the desiccant in order to
maintain its effectiveness.
• Do not remove it from the bag until you are about to use
it.
• Do not wet it or touch it with wet hands.
• Assemble promptly upon adhering the desiccant.
• Be sure to replace the desiccant during maintenance.
2.
Mount the lower housing
Mount the lower housing that is dismantled in Step 2.
(A pg. 10) to the main housing unit using the 3 Screw A
(M4 x 6).
Do so by aligning the position marks of the lower housing
and the main housing unit.
3.
Mount the gasket and gasket gland
Mount the gasket and gasket gland that are dismantled in
Step 1. (A pg. 10) of the housing disassembly procedure
to the lower housing using the 8 Screws B (M4).
CAUTION:
● During assembly, ensure that wires and cables are not
caught in the housing.
● Do not exert force unnecessarily on the gasket or twist it
during mounting.
● Check to ensure that the gasket is in close contact with the
camera.
1.
Drill a hole into the wall.
Drill a hole (R 45 mm) for inserting the connection cable.
(Refer to left fig.)
2.
Affix anchor bolts onto the wall.
• Affix 4 anchor bolts (M8, 35 mm and above) for attaching
the housing. (Refer to left fig.)
• Affix an anchor bolt for attaching the safety wire, in the
middle (about 60 mm from both ends) of the 2 upper
anchor bolts, 30 mm from the top. (Refer to left fig.)
3.
Mount the safety wire and arm to the wall.
• Mount the safety wire attached to the housing, to the
anchor bolts using the nut and wire.
• Use the nut and wire to mount the housing onto the wall.
13