Procedures From Connection To Setting - JVC TK-C215VP12 Instructions Manual

Installation and Connection
Procedures from
Connection to Setting
Follow the procedures below to connect/set this
unit.
Turn off the power of devices to be used before
connecting the cables.
Before touching the camera unit, make
sure to touch the metal surface of the
[MONITOR] terminal to discharge any
static electricity from your body. Static
electricity may cause the camera to
malfunction.
When mounting the base to the ceiling, or
when connecting the cable of the camera
unit, pay enough attention to the fall of
each part.
16
Set the switches
(A Pg. 17)
step 1
Remove the dome cover, followed
by setting the video image
switches.
K
Mounting the base
(A Pg. 17)
step 2
Mount the base to the wall or
ceiling.
K
Connect the cable
(A Pg. 19)
step 3
Connect the coaxial cable and
power supply for the heater.
K
Mounting the camera unit
(A Pg. 20)
Fill the piping hole and screw hole
step 4
with a sealing material, followed
by mounting the camera unit to
the base.
K
Adjusting the video image
(A Pg. 22)
step 5
Adjust the camera's angle, focus
and brightness.
K
Mounting the inner dome
(A Pg. 24)
step 6
After setting is complete, mount
the inner dome to the camera.
K
Mounting the dome cover
(A Pg. 24)
Insert the silica gel into the
step 7
designated space to prevent
fogging of the dome cover,
followed by mounting the dome
cover.