Table of Contents
Advertisement
Camera control unit (rear panel)
DC-IN
1
1 [DC INPUT] DC input connector
Input DC 12 V from the optional AA-V112U power
adaptor.
2 Cover for extension slot
Remove the cover to install an optional device in this
slot.
3 SCSI connector
Used to connect a ZIP or MO drive.
4 [GENLOCK INPUT] external sync signal
input jack
Reference signal input jack used to connect the
camera video output signal in sync with other
equipment such as an HD camera and switcher.
Camera head
(Front view)
1 Lens mount ring
• A special C mount is used. The form is for C
mount, however, the flange back length is 28.0
mm.
Ordinary C mount cannot be used.
The flange back length of an ordinary C
mount conversion lens is 17.526 mm.
• To install a 1/2-inch bayonet mount conversion
lens, use the optional 1/2-inch bayonet mount
conversion adapter (GL-V62U) .
2
(Side view)
1
SYNC OUT
HD
G
VD
B
GEN-LOCK IN
C. SYNC
VS /C. SYNC
R
(75 )
3
4
5
5 [SYNC OUT] sync signal output jacks
Outputs HD (horizontal drive signal)/VD (vertical
drive signal)/C. SYNC.
6 [RGB OUT] RGB signal output jacks
Outputs RGB signals.
7 [Y, P
, P
OUT] video signal output jacks
B
R
Output Y, P
, P
B
R
When video signals are output to an HDTV monitor,
the screen will have a 16:9 aspect ratio, resulting in a
horizontally extended picture.
(Rear view)
2 Camera cable connector
Connect the camera control unit with the optional
camera cable.
HD OUT
Y
P
B
P
R
6
7
signals.
2
13
Advertisement
Table of Contents
