Connections - JVC DZ-VCA1SE Instructions Manual

Connections

Connection example
Notes:
• Do not connect this camera to equipment other than that depicted in these connection diagrams.
• Always be certain to use the AA-V31E Isolation Transformer.
Endoscope Video Adapter GL-V63J*
Endoscope Video Zoom Adapter GL-V64J*
Endoscope
* Always use an adapter that is designed for the Endoscope.
Camera control unit (rear panel)
DC-IN
DC 12 V
AC power
adapter
(AA-V112E)
• The camera head and camera control unit are adjusted as a set. Be sure the serial numbers match.
Optimum picture quality may not be obtained if a different combination is used.
• When the system is connected, check that current leakage from this connection does not surpass the specified
level. Also, be absolutely sure to use an AA-V31E isolation transformer.
• If the exterior of the isolation transformer is corroded, inadequate grounding may result. Have the exterior
replaced by your local JVC dealer.
Endoscope application
SYNC OUT
HD
VD
GEN-LOCK IN
C. SYNC
V S / C . SYNC
(75 )
RGB signal
ZIP drive
Z250S
Isolation transformer
AA-V31E
AC 230 V
Operation field application
1/2" bayonet mount
conversion adapter
Front panel
CAMERA
HD OUT
G Y
B P
B
R P
R
HD video signal
(Y, PB, PR)
HD Monitor
HV-M2000V
Lens
(commercially
(GL-V62J)
available)
Camera head
Camera cable
VC-V10 or VC-V3
(optional)
Camera head
Microscope
adapter GL-V61J
(optional)
Operation microscope application
W-VHS VCR SR-W7 MAE
11