Panel Facilities And Specifications; Front Panel - Pioneer VSX-D209 Service Manual

QQ
3 7 63 1515 0

8. PANEL FACILITIES AND SPECIFICATIONS

8.1 PANEL FACILITIES

Front Panel

1 2 3 4 5 6 7
~
1 MAIN POWER button
Push to send electricity to the receiver. Note the STANDBY/
ON button below actually turns the receiver on and standby.
TE
L 13942296513
2
STANDBY/ON button
Switches the receiver between on and standby.
3 STANDBY indicator
Lights when the receiver is in standby mode (note that the
receiver consumes a small amount of power (1W) in
standby mode).
4 STATION (+/–), FREQUENCY (+/–), TUNING SELECT
buttons
STATION (+/–)
Selects station memories when using the tuner.
FREQUENCY (+/–)
Selects the frequency when using the tuner.
TUNING SELECT
Switches between station memory and frequency select
modes.
5 CLASS button
Switches between the three banks (classes) of station
memories.
6 MEMORY button
Press to memorize a station for recall using the STATION
(+/–) buttons.
7 MPX MODE button
lf the TUNED or STEREO indicators don't light when tuning
to an FM station because the signal is weak, press the MPX
button to switch the receiver into mono reception mode.
www
This should improve the sound quality and allow you to
enjoy the broadcast.
8 Display
.
9 Remote sensor
Receives the signals from the remote control.
http://www.xiaoyu163.com
! @
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
8 9 0 -
# $ % ^
0 DSP MODE button
Use to switch between the various DSP modes available
(HALL, JAZZ, DANCE, THEATER1, THEATER2) and DSP
Q Q
off. Use to create different surround sound effects from any
3 6 7 1 3 1 5
stereo source.
- DOLBY PRO LOGIC button
Use to switch between the various Pro Logic modes (PRO
LOGIC, PRO LOGIC THEATER1, PRO LOGIC
THEATER2) and Pro Logic off.
= MASTER VOLUME
Use to set the overall listening volume.
~ PHONES jack
Use to connect headphones but this does not switch the
speakers off.
! SPEAKER button
Use to switch the speaker system on or off.
@ FL DIMMER button
Use this button to make the fluorescent display (FL) dimmer
or brighter. There are three brightness settings as well as
an off setting.
# BASS ( + /–) buttons
Use to increase/decrease bass (within a range of
6dB in 2dB steps). It cannot be used when S.BASS is on.
$ TREBLE ( + /–) buttons
Use to increase/decrease treble (within a range of
6dB in 2dB steps).
% Function buttons
Use to select a source for playback or recording.
^ S.BASS button
co
Use to switch on and off the bass boost. Use for a more
powerful bass sound. Negates use of BASS buttons.
.
& DIRECT button
Use to switch DIRECT playback on or off. This mode
bypasses the tone controls and channel levels for the most
accurate reproduction of a program source.
VSX-D209, VSX-D209-G
9 4 2 8
=
&
0 5 8 2 9 9 4 2 8
m
9 9
9 9
–6dB to
–6dB to
49