Panel Facilities And Specifications - Pioneer VSX-D810S Service Manual

8. PANEL FACILITIES AND SPECIFICATIONS

8.1 PANEL FACILITIES
Front Panel
2
1
(
1 STANDBY indicator
Lights when the receiver is in standby mode (note that
the receiver consumes a small amount of power (1W) in
standby mode).
2
STANDBY/ON button
Switches the receiver between on and standby (note that
the receiver consumes a small amount of power (1W) in
standby mode).
3 STATION (+/–) buttons
Selects station memories when using the tuner.
4 TUNING (+/–) buttons
Selects the frequency when using the tuner.
5 DIRECT button
Use to switch DIRECT playback on or off. This mode
bypasses the tone controls, channel levels, 2/DTS and
DSP modes for the most accurate reproduction of a
program source.
6 MONITOR button
Press to switch tape monitoring on/off.
7 DIGITAL NR button
Switches the DIGITAL NR on or off .
On the VSX-D810S use this button to switches the
DIGITAL NR on or off.
8 DSP MODE button
Use to switch between the various DSP modes available
(
HALL1, HALL 2, JAZZ, DANCE, THEATER1, THEATER 2,
) and
6CH STEREO DSP off
different surround sound effects from any stereo source.
9 Remote sensor
Receives the signals from the remote control.
0 SIGNAL SELECT button
Use to select an analog or digital or AUTO signal.
- 2 /DTS button
Use to switch between the various Dolby/DTS surround
modes.
= TONE button
This button allows you to activate the BASS & TREBLE
controls. To adjust the BASS and/or TREBLE use the
3 4 5
N∫m-Û˘,?∫
* & ^ % $
. Use this button to create
7
6 8
9
0 -
@
#
MULTI JOG DIAL. Tone can only be used in 2 channel
stereo sound mode. The tones controls have no effect on
the B speaker system.
~ MULTI JOG dial
You can use this dial for two purposes. Firstly, in normal
mode turn it to select a source component. Secondly, use
it to adjust the BASS and/or TREBLE levels when the
TONE button has been activated (as explained above).
! MASTER VOLUME
Use to set the overall listening volume.
@ VIDEO INPUT jacks
Connect a video camera, video game system, etc. to the
jacks.
VIDEO INPUT
# MIDNIGHT button
Use when listening to movie soundtracks at low volume.
This feature will enable you to hear quiet sounds and not
get jolted by loud or sudden sound effects.
$ SPEAKERS button
Use to switch the speaker system
In
B and A+B speaker modes you hear only 2 channel stereo
sound.
% MPX button
lf the or
TUNED STEREO
to an FM station because the signal is weak, press the
MPX button to switch the receiver into mono reception
mode. This should improve the sound quality and allow
you to enjoy the broadcast.
^ BAND button
Press to select the AM or FM band.
& MEMORY button
Press to memorize a station for recall using the
buttons.
(+/–)
* CLASS button
Switches between the three banks (classes) of station
memories.
( PHONES jack
Use to connect headphones but this does not switch the
speakers off.
VSX-D810S
= ~
1
!
= = =
A B A+B off
indicators don't light when tuning
STATION
.
73