Table of Contents
Advertisement
更多难得资料请到江南家电维修论坛免费下载！
http://bbs.520101.com
V. Center Adjustment (VPOS)
Perform this adjustment after performing H. Frequency
(Free Run) Check.
1. Input a crosshatch signal.
2. Activate the Service Adjustment Mode.
3. Select the VPOS item with
4. Adjust value of VPOS with
center.
5. Press
then
H. Center Adjustment (HPOS)
Perform this adjustment after performing H. Frequency
(Free Run) Check.
1. Input a crosshatch signal.
2. Activate the Service Adjustment Mode.
3. Select the HPOS item with
4. Adjust the value of HPOS with
horizontal center.
5. Press
then
H. Size Adjustment (HSIZ)
1. Input a monoscope signal.
2. Activate the Service Adjustment Mode.
3. Select HSIZ with
4. Adjust with
and
5. Press
then
V. Linearity (VLIN), V. Correction (SCOR),
Pin Amp (PAMP), and Horizontal Trapezoid
(HTRP) Adjustments
1. Input a crosshatch signal.
2. Activate the Service Adjustment Mode.
3. Select VLIN, SCOR, PAMP, and HTRP with with
4. Adjust with
and
5. Press
then
and
.
and
for the best vertical
to save into the memory.
and
.
and
for the best
to save into the memory.
and
.
for the best horizontal size.
to save into the memory.
and
for the best horizontal size.
to save into the memory.
V LINEARITY (VLIN)
V CORRECTION (SCOR)
PIN AMP (PAMP)
HORIZONTAL TRAPEZOID (HTRP)
V. Angle (VANG), V. Bow (VBOW), Upper pin
(UPIN) and Low Pin (LPIN) Adjustments
1. Input a crosshatch signal.
2. Activate the Service Adjustment Mode.
3. Select VANG, VBOW, UPIN, and LPIN with
4. Adjust with
and
5. Press
then
V ANGLE (VANG)
V BOW (VBOW)
UPPER PIN (UPIN)
LOW PIN (LPIN)
Service Adjustment Mode Memory
1. Change the value of the DCOL item to "1".
2. After completing all adjustments, press
Read From Memory
Mode
Category
.
service
Signal
Type
ntsc
vchp
— 27 —
KV-34FS12T
and
for the best picture.
to save into the memory.
then
Display
Item
Item
Data
Green
defl
vbow
7
0
Red
00000000 00000000
ENTER
.
.
Advertisement
Table of Contents
