Hard Floor Cleaning; Cleaning After Use - Bissell CleanView Compact Performance 20W7 Series User Manual

O
perations
empty the collection tank (cont)
4. Rinse collection tank thoroughly and
replace on unit.
5. Refill solution tank and continue cleaning.

Hard floor cleaning

(Select models only)
1. Remove the collection tank (refer to
steps 2a and 2b on page 7).
2. Attach the hard floor tool by hooking it
into the front of the removable nozzle
and rotate until it snaps firmly in place.
3. Replace the collection tank. Be sure to
attach the two latches.
4. fill the solution tank with hand hot (not
boiling) tap water to the WATER fill line.
fill the rest with BISSELL 2X hard floor
Solutions™ to foRmULA fill line.
5. follow steps 1-8 under "Carpet Cleaning"
on page 7 to continue cleaning.

cleaning after use

1. Unplug the unit.
2. Remove and rinse collection tank thoroughly.
3. Remove tank vent & foam filter (located
on top of the collection tank) and rinse.
4. Clean nozzle window by lifting latch
and removing nozzle from machine.
Rinse under running water.
5. When finished replace nozzle and
secure with latch.
note: for best results, it is
recommended that the nozzle
is cleaned after each use.
6. Remove lint and hair from red gasket in
base of unit. (Do not remove gasket)
7. Replace the collection tank on the base
of the machine and secure with latches.
8
w w w . b i s s e l l . c o m
WaRning:
To reduce the risk of injury from
moving parts and/or electrical
shock, turn power switch
OFF and disconnect plug
from electrical outlet before
performing maintenance or
troubleshooting checks.
2.
caution:
Do not store unit where freezing
may occur. Damage to internal
components may result.
3.
5.
4.
4.
6.