Motorola PM1200 User Manual page 38

Radio Firmware Features
11.0 Entering Programming Mode
Connect the TELCO programming cable from the personal computer
to the PM1200 mobile.To enter programming mode, press and hold
the power button and PF3 button simultaneously for a few
seconds.The control head will display "PC CLONE". Then
programming can be done via the personal computer.
11.1 Radio-CPS-Radio Cloning
This feature allows cloning of the CPS configurable radio
programming data and personalities information between two radios
via the CPS. Cloning can be done only if the Target and the Source
radios are of the same model type and firmware version.
When the radio enters cloning mode, a momentary tone sounds and
"PC CLONE" appears on the display.
Cloning process will be aborted off both the Target and the Source
radios are of different model.
During cloning, only the CPS configurable data will be cloned. Model
number, Serial Number & Tuning Parameters will not be cloned.
12.0 The Option Board Features
The PM1200 Digital ANI ENCODER(*) (MDC1200 & DTMF
Identification Encoder) and the PM1200 Quik-Call II Decoder are
available for the PM1200 mobile.
12.1 PM1200 Digital ANI Encoder
PM1200 Digital ANI Encoder is the option board capable of PTT ANI
(PTT ID) and Emergency ANI in MDC1200 or DTMF signaling. The
unit provides Automatic Numeric Identification of a specific radio
transmitter each time the microphone PTT button is pressed.
Emergency messages are sent by pressing the assigned
'Emergency' PF button.
Manual DTMF generation is available as well as automatic ANI.
26