Sv8100 Netlink - NEC Univerge SV8100 Features And Specifications Manual

Hide thumbs Also See for Univerge SV8100:

Table of Contents

UNIVERGE SV8100

Enhancements

This feature added with Version 1100 (Version 1.12 or higher).

The NetLink feature allows up to 16 sites to be linked together over a Data Communication IP NetLink

that allows Remote Sites to have the same service features as the Main Site, acting as one system.

Systems can be installed separately in the same building or in remote offices connected via a qualified

With NetLink, the maximum system capacity still applies (200 Trunks and 512 Stations), but the ports

can be distributed between sites using an SV8100 CHS2U-US chassis at each location.

Each site must have a PZ-(X)IPLA daughter board and a PZ-ME50-US Memory Expansion Daughter

Board installed on its CD-CP00-US blade. The CD-CP00-US blade at each Remote Site must have the

same data as the Main Site CD-CP00-US blade. The Main Site automatically uploads the system data

to the Remote Sites anytime it changes.

The Main Site requires a proper LK-SYS-NETLINKX-LIC license for each Remote Site.

When a communication failure occurs between the Main Site and any Remote Site, the Main Site

CD-CP00-US blade automatically changes to survival mode and operates as a stand-alone system. If

multiple Remote Sites are installed, a Remote Site can be assigned as a temporary Main Site to control

remaining connected sites.

The Primary System (Main Site) requires the appropriate NetLink licenses dependant upon

the number of nodes in the NetLink network.

Up to 16 Nodes can be supported in a NetLink network.

A maximum of 240 Virtual slots are supported.

Port assignment is performed sequentially by the requested order from the Secondary

All nodes in a NetLink network should have the same main CD-CP00-US software.

SV8100 NetLink