Advertisement
Glue Plate Method
You have the option to glue the Helmet Clamp onto your helmet,
when the above standard method cannot be used, or in case you
prefer to secure the Helmet Clamp with adhesive glue. This option
has been successfully used for a range of high end helmets.
NOTE: While we have no reason to believe that the gluing option might
negatively affect any helmet, Cardo does not assume any responsibility to
that affect, irrespective of its nature and circumstances. The Glue Plate is
offered as a free option that you may choose to use at your own risk and
subject to renouncement of any future claims.
Caution: This process can be done only once!
1. Use the enclosed Allen Wrench to remove both
Allen screws and release the Helmet Clamp's back
plate.
2. Determine the location on the helmet where the Helmet Clamp
must be attached.
3. Adjust the Helmet Clamp's location on
the Helmet so that the microphone is lo-
cated opposite the center of your mouth.
You may need to reposition the Clamp
repeatedly until you identify the best spot.
The microphone must be positioned vertically and not hori-
zontally (Be sure to clean the selected area prior to the gluing
process as described in # 4 below).
4. Use the pre-moistened Towelette to clean the helmet area
where you want to install the Glue Plate. Allow to dry thorough-
ly.
5. Peel the foil cover from the Glue Plates' adhesive pad.
Audio & Microphone User Guide
CORRECT
INCORRECT
Advertisement
