Sensitivity Settings Of The Dust Sensor - Daikin MC707VM-S Manual

Operation Manual
Care and Cleaning
Cleaning the deodorization catalytic unit
• Vacuum dusts with a
cleaner without
removing from the
main unit.
(Do not wash.)

Sensitivity settings of the dust sensor

The sensitivity of the sensor differs depending on the size of
room, installation place, and type of dirt.
Change the sensor sensitivity if you don't like it.
1. Press " " on the main unit for 10 seconds with the
remote controller pointed at the main unit while holding
" " .
• The receiving tone sounds, one of "
" " M (Standard) and "
and then the lamp corresponding to the set sensitivity turns on.
2. Change the settings using the "
Stop] button of the main unit.
• Switches each time it is pressed.
• The settings is shown in the airflow rate indicator.
Airflow speed "
display L (Low)
High
Dust sensor (Sensor display
sensitivity becomes easy
to light.)
3. When you decide on the settings, point the remote
controller at the main unit and press the "
[OFF TIMER] button.
• The receive sound will beep and the setting lamp will flash.
4. Unplug the power plug one time and then after
3 seconds or more plug it in again.
• This completes the settings.
Airflow rate indicator
Off timer button
15
26
" L (Low),
" H (High) lamps blinks for 5 seconds,
" [Operation switch/
" " " " "
M (Standard) H (High)
Low
Normal
(Sensor display
(setting when
will have difficulty
shipped)
coming on.)
"
Operation switch /
stop button
NOTE
•
If the operation of 4. is not performed, the unit will not return to
normal operation mode. If the operation of 4. is performed, during
the settings, the settings will not be correct.
•
When the sensitivity is set high, it will become difficult for the sensor
lamp to go out.
Optional accessories
• For replacement pleated filter and bio-antibody filter, contact your
dealer.
Part name
Pleated filter
(7 sheets)
Bio-antibody filter
(1 sheet)
• If used with dirty parts;
• Cannot obtain air clean effect.
• Cannot obtain deodorization effect.
• Odor may arise.
Disposal requirements
Your Daikin product is marked with this symbol. This
means that electrical and electronic products shall not
be mixed with unsorted household waste.
Disposal of this product must be done in accordance
with relevant local and national legislation. By disposing
of this product correctly, you will help ensure its proper
treatment, recovery and recycling, thus preventing
potential negative consequences for the environment and human
health. Please contact your local authority for more information.
Batteries must be removed from the remote controller and disposed of
separately in accordance with relevant local and national legislation.
SiBE81-623A
Part number
KAC972A4E
KAF972A4E
Photocatalytic Air Purifiers