Drainage - Dimplex DAC 9005 Instruction Manual

DRAINAGE IN HIGH HUMIDITY CONDITIONS -
AND STORAGE ONLY
During the process of cooling, water will be generated from the air and collected in the
water tank inside the unit.When the tank is full, the compressor will stop and the Full
Water indicator on the control panel will come on to remind you to empty
the water tank. During this time the fan
will continue to operate circulating the air.
The water tank should be emptied as
follows:
1. Turn off the unit.
2. Position the supplied plastic water tray,
flat on the floor, under the drain hole.
3. Remove the water stopper and the
rubber plug. Empty the condensed
water from the air conditioner.
4. When the water tray is almost full,
replace the rubber plug to stop the
flow of water, empty the water tray.
5. Repeat step 2, 3, 4, till all the condensed
water is emptied.
6. After all condensed water is drained,
replace the rubber plug and water
stopper.
The FULL WATER indicator should be off now.
ATTENTION!
1. All condensed water must be drained prior to relocation or storage.
Rubber
plug
9
Water stopper
Water
tray