Monitor - Yaesu FT DX 3000 Operating Manual

T
ranSMiTTer
You may listen to the quality of your transmitted signal using the Monitor feature.
1. Press the [ MONI ] button. The LED inside the [ MONI ]
button glows orange.
2. During transmission,
adjust the audio level in the Headphones or speaker.
Clockwise rotation of this knob will increase the vol-
ume level.
3. To switch the Monitor off again, press the [ MONI ]
button once more. Confirming that the Monitor is
now disengaged.
A :
dvice
 Because the Monitor feature samples the transmit-
ter IF signal, it can be very useful for checking the
adjustment of the Speech Processor or Parametric
Equalizer on SSB, and for checking the general sig-
nal quality on AM and FM.
A :
dvice
 To adjust the Monitor level:
1) Activate the MONI circuitry, if necessary.
2) Press and hold in the [ MONI ] button for one sec-
ond to enter Menu item "035 MONITOR LEVEL".
3) Press the [ SELECT ] button .
4) While speaking into the microphone, rotate the
[ CLAR/VFO-B ] knob (or press the p/q button)
to adjust the monitor level.
5) When you are satisfied with the setting, press
the [ SELECT ] button, then press the [ MENU ]
button to save the new setting and exit to normal
operation.
FT 3000 O
DX peraTing
mOniTOr ( ssb/Am/Fm
rotate the [ MONI ] knob to
M
anual
c
Onvenience
mOdes
F
eaTureS
)
[ MONI ] Button
Page 73