Pride jazzy 1120 Owner's Manual page 10

I I I .
UTILITY TRAY
The utility tray is located on the rear of your Jazzy. See figure 2. A section of the utility tray is exposed through the
body shroud. The rest of the utility tray is located underneath the rear door. The utility tray consists of the ammeter,
the battery charger power lead, the main circuit breaker, the standard headlight/taillight connector, the full lighting
harness connector (optional), and the Remote Plus controller harness connector. See figures 3 - 5.
n Ammeter: The ammeter displays the charger’s current output in amps. See figure 3. For more information,
see VIII. “Batteries and Charging.”
n Battery charger power lead: This lead is used whenever your battery needs recharging. See figure 3.
n Main circuit breaker: The main circuit breaker is a safety feature built into your Jazzy 1120. See figure 4.
When the batteries and the motors are heavily strained (e.g., from excessive loads), the main circuit breaker
trips to prevent damage to the motors and the electronics. If the circuit trips, allow your Jazzy to “rest” for
approximately one minute. Next, push in the circuit breaker button, turn on the joystick controller, and continue
normal operation. If the main circuit breaker continues to trip repeatedly, contact your authorized Pride provider.
n Remote Plus controller harness connector: This is where the joystick connects to the motors, batteries, and
charger. See figure 3.
n Full lighting harness connector: This 4-pin plug located in the rear utility tray is where the lighting harness
connects to the controller. See figure 5.
STANDARD HEADLIGHT/
TAILLIGHT CONNECTOR
Figure 4. Main Circuit Breaker
10
T H E J A Z Z Y
MAIN CIRCUIT BREAKER
1 1 2 0
FULL LIGHTING HARNESS CONNECTOR
Figure 5. Full Lighting Harness Connector
Jazzy 1120