Programming Example; Additional Information - Panasonic KX-TA308 Installation Manual

4.1 Before System Programming

Programming example

The following programming instructions assume that you have already entered the
programming mode.
Example: Program [404] "Outside (CO) Line Group Assignment"
Program address
[404] Outside (CO) Line Group Assignment
Assigns a maximum 6 outside (CO) line groups. Each outside (CO) line must be assigned to
an outside (CO) line group. For example, if there are multiple telephone service companies
available, outside (CO) lines can be grouped by the company.
4 0
* Outside (CO) line number: 1 through 6 /
1
* 2 Outside line (TRK) group number: 1 through 6
Default Outside (CO) line 1 through 6 – Outside (CO) line group 1 through 6
!
!
• Each outside (CO) line can only belong to one outside (CO) line group.
• Feature Reference
Section 3, Features
Outside Calling

Additional information

Provides the factory default setting. If you change the setting,
write the programmed data in the programming table listed in
section 7, Programming Tables.
Additional Information
• When you press
been assigned as outside (CO) line group 1, "CO
each outside (CO) line has been assigned to a different outside (CO) line group,
"CO
• You can press the SELECT button repeatedly to select the desired parameter, if available.
• You can use the
4-4
System Programming
Program title
4 outside line no.*
NEXT
(1···6/ )
, for example in step 3 in program [404], if all outside (CO) lines have
: Mixed" will be displayed.
or
or
NEXT PREV
outside line group no.*
1
(1···6)
SELECT
(All outside lines)
button to move to the next/previous step, if available.
To continue
2
STORE
END
To continue
Program sequence:
1. Enter program address "404".
2. Press "NEXT".
3. Enter the outside (CO) line
number (1 through 6) or press
to select all outside (CO) lines.
4. Enter the outside (CO) line
group number (1 through 6).
5. Press "STORE".
6. Press "END".
To continue assigning another
outside (CO) line number, press
"SELECT" instead of "END"
and repeat from step 3.
You can also continue assigning
by pressing "PREV" or
"NEXT" instead of "END".
You can go to the previous or
next outside (CO) line and
repeat from step 4.
: TRK GRP – 1" will be displayed. If
Program
description