Table of Contents
Advertisement
Putting a Call on Hold
Press
to put a call on hold.
YES
To put the call off hold, press
again.
YES
Useful Information while Talking
This chapter describes how you can: change the volume of the ear piece; use the display as a
scratch pad; send DTMF tones; check the duration of the current call; show or hide your
phone number (CLI – Calling Line Identification); handle two calls simultaneously.
Changing Volume
while Talking
During a call, you can use the arrow keys to in-
crease or decrease the ear piece volume.
Muting Microphone
Press and hold the
key.
CLR
Using Phone
as Scratch Pad
1. Enter a phone number on the keypad while
talking.
When you end the call, the number remains
in the display.
2. Press
to make the call in the display.
YES
LZT 126 1352/7 R1A
Sending
Tone Signals
, * and #
During a call you can press keys
–
0
9
to send DTMF tones. For example, to perform
banking by phone or to control an answering
machine.
Checking
Time of Calls
When you start a call (incoming or outgoing),
the airtime is counted in minutes and seconds
and shown on the display, like this:
1:34
About Calling Line
Identification (CLI)
The Calling Line Identification service shows
the caller's phone number when you receive a
call (you have to order this service from your
network provider). If the caller's name is stored
in your phone book, you will see both the name
and number.
Showing Your
Phone Number
If you subscribe to normally withhold your
number when calling, you can show the number
on a particular call.
1. Enter the number you wish to call.
2. Press R .
The display shows Send Id?
3. Press
to make the call.
YES
7
Advertisement
Table of Contents
