Enterasys X-Pedition XSR-1850 Getting Started Manual page 90

System Specifications
Table A-1
Category
Redundant
Power System
& Power
Chassis
I/O Interfaces
I/O Interfaces
Chassis LEDs
A-2
XSR Hardware Specifications (continued)
Dimensions
Weight
AC Input Voltage/Freq. 90 - 264 VAC (47-63 Hz) [same for internal power supply]
Power Consumption
+5.1V DC output
+12V DC output
-12V DC output
Operating
Temperature
Non-Operating temp.
Relative Humidity
MTBF
Onboard (LAN)
NIM (WAN) Slots
NIM (LAN or WAN)
10
Parameters
Power System: 5" long by 4" wide by 1.4" high
Power Chassis: 1.72" high (1U) by 19" wide by 11" deep
Power System: 1.75 lbs
Power Chassis: 8.5 lbs
Total power: (100 - -240~ Volts) 25 Watts
7A maximum, 35.7 Watts maximum [same as internal]
1A maximum, 12 Watts maximum [same as internal]
.2A maximum, 2.4 Watts maximum [same as internal]
0 - 40° C
-40 - 70° C
5% - 90%, non-condensing
> 150,000 hours
2 10/100Base-T Ethernet ports with RJ-45 connectors
RS-232 Console serial port with DB-9 connector
Dual or Quad synch/asynch Serial ports with DB-type connector
also supporting X.21, V.35, EIA-449, EIA-232/530 & combined
V.35/EIA-232/530 DTE interfaces with adapter
Single, dual, or quad T1/E1 RJ-48C port(s) with integral CSU/
DSU. Full-channel, fractional or unchannelized.
Single port T3/E3 un-channelized NIM with BNC connectors
Dual or quad port BRI/PRI S/T NIM (RJ-45) or U NIM with RJ-45
or RJ-49C connectors, respectively.
Single port Annex A/C or B ADSL NIM with RJ-11 connector.
Includes CompactFlash card
Dual port T1/E1 Drop and Insert NIM with RJ-45 connectors
Single port 10/100Base-T Copper or 10/100Base-F Fiber-optic
Ethernet NIM with RJ-45 connector or MT-RJ multi- mode
interface, respectively.
Display port and system status, warn of Flash upgrade