Service Note; Power Supply During Repairs; To Take Out A Disc When Not Eject (Force Eject); Setting The "Forced Power On" Mode - Sony DCR-DVD505 Service Manual

1-1. POWER SUPPLY DURING REPAIRS

In this unit, about 10 seconds after power is supplied to the battery terminal using the regulated power supply (8.4V), the power is shut off so
that the unit cannot operate.
These following method is available to prevent this.
Method:
Use the AC power adaptor (AC-L200).

1-2. TO TAKE OUT A DISC WHEN NOT EJECT (FORCE EJECT)

1 Remova the screw (M1.7) and front cover (198)
2 Insert the wire etc. in the hole and down the eject slider by it.

1-3. SETTING THE "FORCED POWER ON" MODE

It is possible to turn on power by adjustment remote commander (RM-95 or NEW LANC JIG).
Operate the camcorder using the adjustment remote commander.
1-3-1. Setting the "Forced Movie Power ON" Mode
1) Select page: 0, address: 01, and set data:01.
2) Select page: A, address: 10, set data:01 and press the "PAUSE (Write)" button of the adjustment remote commander.
1-3-2. Setting the "Forced Play/Edit Power ON" Mode
1) Select page: 0, address: 01, and set data:01.
2) Select page: A, address: 10, set data:02 and press the "PAUSE (Write)" button of the adjustment remote commander.
1-3-3. Exiting the "Forced Power ON" Mode
1) Select page: 0, address: 01, and set data:01.
2) Select page: A, address: 10, set data:00 and press the "PAUSE (Write)" button of the adjustment remote commander.
3) Select page: 0, address: 01, and set data: 00.
DCR-DVD505/DVD505E/DVD905/DVD905E_L2
Charge
lever
Eject slider

1. SERVICE NOTE

Hole
Front cover (198)
1-1
ENGLISH JAPANESE
ENGLISH JAPANESE
Screw (M1.7)