Ryobi RLT30CESA Operator's Manual page 12

TO ATTACH THE GRASS DEFLECTOR ON THE BRUSH
CUTTER GUARD
See Figure 6. (RBC30SESA)
Attach the grass defl ector to the blade guard by placing
n
the three locking tabs into the three notches.
Snap the blade guard and grass defl ector together to
n
lock into place.
WARNING
Always stop the engine and remove the spark
plug wire before making any adjustments such
as changing cutting heads; this is to reduce the
risk of serious personal injury.
ATTACHING THE SHOULDER HARNESS
.
See Figure 7 (RBC30SESA)
Connect the latch on the shoulder harness to the strap
n
hanger.
Adjust the strap to a comfortable position.
n
CONVERTING FROM BRUSH CUTTER TO
STRING TRIMMER
To convert from the brush cutter to the string trimmer,
n
remove the blade, attach the grass defl ector and install
the string head.
REMOVING THE TRI -ARC
See Figures 8 - 9. (RBC30SESA)
Align the slot in the fl anged washer with the slot in the
n
gear head.
Place the gear head locking tool through the slot in the
n
fl anged washer and gear head.
Remove the blade nut by turning it clockwise.
n
Remove the cupped washer and the blade.
n
Remove the fl anged washer from the gear head shaft
n
and retain it for the string head installation.
NOTE: Store the brushcutter parts together for later
use.
INSTALLING THE GRASS DEFLECTOR AND
LINE HEAD
See Figures 10. (RBC30SESA)
Install the grass defl ector. Refer to ʻTo attach the grass
n
defl ector on the brush cutter guard' earlier in this
manual.
Place the fl anged washer on the gear head shaft.
n
NOTE: The hollow side of the fl anged washer should
face the gear head.
(RBC30SESA)
BLADE
®
ASSEMBLY
GEAR HEAd
LOckInG TOOL
GEAR HEAd
SLOT
1
Fig. 7
Fig. 8
Fig. 9
fLAnGEd wASHER
ARBOR
BOLT
STRInG HEAd
Fig. 10