CHILD
RESTRAINT
SYSTEM
INSTALLATION
Type A—
1. Widen
the clearance
between
seat cushion and seatback a little
and confirm the position of the low-
er anchorages below the tag in the
seatback.
2. Latch the hooks of lower straps onto
the anchorages and tighten the lower
straps.
Type B—
1. Widen
the clearance
between
seat cushion and seatback a little
and confirm the position of the low-
er anchorages below the tag in the
seatback.
2. Latch the buckles onto the anchor-
ages.
If your child restraint system has a top
strap, it should be anchored. (For the
installation of the top strap, see "—Using
a top strap" on page 79 in this section.)
For the installation details, refer to the
instruction manual
equipped
with each
product.
82
'01 HIGHLANDER_U (L/O 0106)
CAUTION
D
When using the lower anchorages
the
for the child restraint system, be
sure that there are no irregular ob-
jects around the anchorages or that
the seat belt is not caught.
D
Push and pull the child restraint
system in different directions to be
sure it is secure. Follow all the
installation instructions provided by
its manufacturer.
D
After securing the child restraint
the
system, never recline the seat.
D
Do not put a child restraint system
on the rear seat if it interferes with
the lock mechanism of the front
seats. This can cause severe injury
to the child and front passenger in
case of sudden braking or a colli-
sion.
2001 MY HIGHLANDER_U (OM48432U)
Tilt steering wheel
To change the steering wheel angle,
hold the steering wheel, push down the
lock
release
lever,
tilt
the
wheel to the desired angle and return
the lever to its original position.
steering