Garmin GNC 420A Installation Manual page 118

The following table describes the Type 2 output sentence item designator (id), sequence number (seq),
waypoint identifier (wpt), waypoint latitude (lat), waypoint longitude (lon), and magnetic variation at
waypoint (mvar) fields.
Field Byte
id 1
2-3
seq 1
wpt 1-5
lat 1
2
3
lon 1
mvar 1-2
Page C-4
Page Rev L
Format
7 6 5 4 3 2 1 0
x l a n n n n n
s d d d d d d d
x x m m m m m m
x h h h h h h h
s x x x x x x x
d d d d d d d d
x x m m m m m m
x h h h h h h h
Description
ASCII character 'w' (77 hex)
Two ASCII numeric characters representing route
sequence number of waypoint (01 to 31)
x - undefined
l - 1 if last waypoint in route
a - 1 if active to waypoint
nnnnn - route sequence number of waypoint
(unsigned binary)
Destination waypoint identifier (will be blank filled on
right if less than 5 characters in identifier)
s - 0 (north) or 1 (south)
ddddddd - latitude degrees (unsigned binary)
xx - undefined
mmmmmm - latitude minutes (unsigned binary)
x - undefined
hhhhhhh - hundredths of latitude minutes
(unsigned binary)
s - 0 (north) or 1 (south)
xxxxxxx - undefined
dddddddd - longitude degrees (unsigned binary)
xx - undefined
mmmmmm - latitude minutes (unsigned binary)
x - undefined
hhhhhhh - hundredths of latitude minutes
(unsigned binary)
Two's complement binary in 16ths of degrees.
Easterly variation is positive. MSB output first.
400 SERIES INSTALLATION MANUAL
P/N 190-00140-02