Getting Started; Unpacking; Connecting The System Control Cable And The External Wire - JVC XM-G6 Instructions Manual

Minidisc recorder
Hide thumbs Also See for XM-G6:
Table of Contents

Advertisement

Getting Started

Unpacking

After unpacking, check to be sure that you have the
following items.
• Optical digital cable (1)
• External wire (1)
The number in the parentheses indicates the quantity of the
pieces supplied. If any is missing, consult your dealer
immediately.
Connecting the System Control Cable and
the External Wire
Since XM-G6 Mini Disc Recorder is exclusively designed
for UX-G6R micro component system, you can easily
connect this unit using the system control cable and
connector equipped on the rear panel of each unit as
illustrated.
• To prevent malfunction, connect the external wire as
illustrated.
Optical digital cable (supplied)
External wire (supplied)
XT-UXG6R
XM-G6
XT-UXG6R
Before connecting the unit, remove
the protective plug from the terminal.
5
DIGITAL OUT
AX-UXG6
FROM CONNECTOR-C
TO CONNECTOR-C
AUX
System control cable-C
Protective Plug
When connecting the XM-G6 MD recorder
Make sure to turn off UX-G6R and unplug the AC
power cord. Leave it until all the connections
complete.
DO NOT place XM-G6 unit or any other
equipment onto AX-UXG6 stereo amplifier unit.
Damage or malfunction may result from heat
generating portion of AX-UXG6.
1
Turn off UX-G6R system and unplug the AC power
cord from the wall outlet.
2
Place the UX-G6R's units onto the XM-G6 unit.
For example as follows, from top to bottom: AX-UXG6,
XT-UXG6R, TD-UXG6, finally XM-G6.
3
Using the system control cable-C, connect XM-G6
unit to XT-UXG6R unit.
When connecting the system control cable to the
connecter
Make sure to connect the cable to the terminal having
the same name as "FROM CONNECTOR-C" and
"TO CONNECTOR-C. "
• To connect the system control cable, press the middle
of the connector body until it clicks into the terminal
on the rear panel.
• To disconnect, pull the connector out pushing both
sides of the connector body. Never pull out the cables
themselves.
To connect
4
Using the Optical digital cable, connect between
XM-G6 unit and XT-UXG6R unit.
Now you have finished installation of XM-G6 unit to
UX-G6R system.
To disconnect

Advertisement

Table of Contents
loading

Table of Contents