Table of Contents
Advertisement
Introduction
We would like to thank you for purchasing one of our JVC products.
Before operating this unit, read this manual carefully and thoroughly
to obtain the best possible performance from your unit,
Welcome to XM-G6
XM-G6 is MiniDisc Recorder exclusively designed for UX-
G6R micro component system. Although you cannot operate
this MD recorder without UX-G6R, this integration offers
enhanced features to simple and easy operations
systematized on UX-G6R.
Since the basic settings and common operations are almost
identical to those of UX-G6R, this manual mainly explains
MD related operations. Concerning UX-G6R's settings and
operations, refer to its Instructions for details.
• The following marks are used in this manual:
Gives you warnings and cautions to prevent
from a damage or risk of fire/electric shock.
Also gives you information which is not good
for obtaining the best possible performance
from the unit.
Gives you information and hints you had
better know.
1
and retain this manual for future reference.
Precautions
Installation
• Install in a place which is level, dry and neither too hot
nor too cold — between 5˚C (41˚F) and 35˚C (95˚F).
• Install the unit in a location with adequate ventilation to
prevent internal heat built-up in the units.
• Leave sufficient distance between the unit and a TV.
DO NOT install the units in a location near heat
sources, or in a place subject to direct sunlight,
excessive dust or vibration.
Power sources
• The power source of this unit is controlled by UX-G6R's
system operation. Refer to its Instructions.
• When connecting the unit to the UX-G6R, make sure to
unplug the AC power cord of the UX-G6R from the wall
outlet.
Moisture condensation
Moisture may condense inside the unit in the following
cases:
• After starting heating in the room
• In a damp room
• If the unit is brought directly from a cold to a warm place
Should this occur, the system may malfunction. In this case,
leave the unit turned on for a few hours until the moisture
evaporates, unplug the AC power cord, and then plug it in
again.
DO NOT disassemble the unit since there are
no user serviceable parts inside.
If anything goes wrong, unplug the AC power cord and
consult your dealer.
Advertisement
Table of Contents
