GE 16 Owner's Manual And Installation Instructions page 64

Before you call for service...
Troubleshooting Tips
C/)
.~
t
2
oW
C/)
.s
~
~
~
Possible Causes What To Do
Oven temperature too
Oven thermostat • See the Adjust the oven thermostat -Easy to do
hot
or too
cold
needs adjustment. yourself! section.
Clock and timer do Plug on range is not completely
• Make sure electrical plug is plugged into a live, properly
not work
inserted in the electrical outlet. grounded outlet.
A fuse in your home may be
• Replace fuse or reset circuit breaker.
blown or the circuit breaker
tripped.
Oven controls improperly set.
• See the Using the clock, timer and convenience outlet
section.
: Display goes blank
A fuse in your home may be
• Replace the fuse or reset the circuit breaker.
blown or the circuit breaker
tripped.
The clock is turned off from
• See the Using the clock, timer and convenience outlet
showing in the display. section.
i
Oven
door is crooked
The door is out of position. • Because the oven door is removable, it sometimes
gets out of position during installation. To straighten
the door, push down on the high corner.
•Oven makes
. !
clicking noise
This is the sound of the
heating element turning
off and on during
cooking functions.
• This is normal.
:"F-ond a number
You have a function error code. • Press the OFF pad. Put the oven back into
!
or letter" flash in
operation.
, the display
If the function code repeats: • Disconnect all power to the range for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.
• On self-cleaning models, if a function error code
appears during the self-cleaning cycle, check the oven
door latch. The latch may have been moved, if only
slightly, from the locked position. Make sure the latch
is moved to the right as far as it will go. Press the
OFF pad. Allow the oven to cool for one hour. Put
the oven back into operation.
Power outage
Power outage or surge. • Some models will automatically resume their setting once
the power is restored. On models with a clock, you must
t
reset the clock. If the oven was in use, you must reset it by
o
pressing the OFF pad, setting the clock and resetting any
~
cooking function.
V')
L­
Display nashes Power failure.
• Reset the clock.
eu
E
::s
C/)
c:
Unable
to
get the display
toshow"SF"
Oven control pads were not
pressed properly.
• The BAKE and BROIL pads must be pressed
at the same time and held for 3 seconds.
8
34