GE 16 Owner's Manual And Installation Instructions page 55

GEAppliances.ca
Oven Heating Elements
Do not clean the bake element or the broil
To clean the oven floor. gently lift the bake
element. Any soil will burn off when the
element. Clean with warm soapy water.
elements are heated.
~r~
~~
,
Wire cover holder
Oven Racks
Clean the oven racks with an abrasive
cleanser or scouring pad. After cleaning,
rinse the racks with clean water and dry with
a clean cloth.
NOTE: Take the racks out of the oven before
you begin the self-clean cycle or they may
discolor.
Oven Light Replacement
(on some models)
A
CAUTION:
Before
replacing your oven light bulb, turn the oven
light off and disconnect the electrical power
to the range at the main fuse or circuit
breaker panel.
Be sure to let the light cover and bulb cool
completely.
To remove the cover:
[l]
Hold a hand under the cover so it
doesn't fall when released. With fingers
of the same hand, firmly push back
the wire cover holder. Lift off the cover.
Do not remove any screws to remove
the cover.
[£]
Replace bulb with a 40-watt household
appliance bulb.
To make the racks slide more easily, apply a
small amount of vegetable oil or cooking
oil to a paper towel and wipe the edges of
the oven racks with the paper towel.
To replace the cover:
[l]
Place it into groove of the light
receptacle. Pull wire forward to
the center of the cover until it snaps
into place.
[£]
Connect electrical power to the range.
Press down and pull out.
Removable Oven Floor
To remove the oven floor:
[l]
Remove knurled screws.
[£]
Press down and pull out the removable
oven floor.
G!l
Clean the oven floor with warm soapy
water.
[f]
When reinstalling the oven floor.
be sure to slide it all the way to
the back of the oven.
IMPORTANT: Always replace the removable
floor before the next use.
25