Table of Contents
Advertisement
1.8 Cabling
Follow these steps for a trouble-free start of the print server operations
with NetServer Pro.
1. Confirm proper operation of the printer to be connected to the print
server.
2. When you have confirmed proper operation of the printer, turn off its
power.
3. Confirm that your network is operating normally.
4. Connect the print server to the network (through the RJ-45 connector
of the print server or its IEEE802.11g wireless interface).
5. While the printer is powered off, plug NetServer Pro to the printer
(USB interface).
6. Turn on the printer's power.
7. Connect the DC end of the AC Power adapter to the DC power input
socket of NetServer Pro and the AC end to the wall outlet. This will
supply power to the print server immediately.
Configuration problems may result if the print server is
powered up without first establishing its network
connection.
Please follow this procedure to avoid
complications at the configuration stage.
NetServer Pro is built with a default IP Address. To
prevent from any conflict in your network, it is
recommended to use the PS-Utility program to
change the IP setting when there is some other
device's IP Address is the same as the print server's
default IP Address.
NetServer Pro
15
Advertisement
Table of Contents
