4
WLAN
1.6 The Rear Ports
Port
1
LAN
2
USB
3
POWER (jack)
4
RESET
1.7 Default Settings
Before you configure the NetServer Pro, you need to know the following
default settings:
Username:
Password :
IP address : 192.168.0.1
Steady light confirms that the print server
has a good connection to your wireless
network.
When it blinks (briefly dark), the print
server is receiving/ transmitting data
from/to the wireless network.
Meaning
The NetServer's Pro rear panel features
an RJ-45 connector for connections to
10Base-T Ethernet cabling or 100Base-
TX Fast Ethernet cabling.
There is a fast USB connector located on
the rear panel of the NetServer Pro,
providing connection for one Printer.
Connect the supplied power adapter to
this jack.
Press this button for 10 seconds to
restore factory default setting.
NetServer Pro
14