KV-36FS12/36FS16/36FV16/36FV26
V. Size Adjustment (VSIZ)
1. Input a cross-hatch signal.
2. Set to Service Adjustment Mode.
3. Select VSIZ with
and
4. Adjust with
and
for the best vertical size.
5. Write into the memory by pressing
.
V. Position Adjustment (VPOS)
1. Input a cross-hatch signal.
2. Set to Service Adjustment Mode.
3. Select VPOS with
and
4. Adjust with
and
for the best vertical center.
5. Write into the memory by pressing
.
H. Size Adjustment (HSIZ)
1. Input a monoscope signal.
2. Set to Service Adjustment Mode.
3. Select HSIZ with
and
4. Adjust with
and
for the best vertical size.
5. Write into the memory by pressing
.
H. Position Adjustment (HPOS)
HPOS Range is from 0~15.
1. Input a monoscope signal.
2. Set the Service Adjustment Mode.
3. Select HPOS with
and
4. Adjust with
and
for the best horizontal center.
5. Write into the memory by pressing
.
.
then
.
then
.
then
.
then
—
V Linearity (VLIN), V Correction (VSCO),
Pin Amp (PAMP) And Pin Phase (PPHA)
Adjustments
1. Input a cross-hatch signal.
2. Set to Service Adjustment Mode.
3. Select VLIN, VSCO, PAMP, and PPHA with
4. Adjust with
and
for the best picture.
5. Write the memory by pressing
V LINEARITY(VLIN)
VS CORRECTION (VSCO)
PIN AMP (PAMP)
PIN PHASE (PPHA)
V Angle (VANG), V Bow (VBOW), Upper Pin
(UPIN) And Low Pin (LPIN) Adjustments
1. Input a monoscope signal.
2. Set to Service Adjustment Mode.
3. Select VANG, VBOW, UPIN, and LPIN with
4. Adjust with
and
for the best picture.
5. Write the memory by pressing
V ANGLE (VANG)
V BOW (VBOW)
UPPER PIN (UPIN)
LOW PIN (LPIN)
28 —
and
.
then
.
and
.
then
.