Whirlpool W10298850 Technical Data Manual page 22

FOR SERVICE TECHNICIAN ONLY - DO NOT REMOVE OR DESTROY
N.O. Heater
Black Relay 1
N.O. COM
Black Red
Figure 16. Machine control electronics.
2. Remove the screw that fastens the assembly
to the machine control mounting bracket (figure
15, page 21), and the two screws that fasten the
console assembly to the dryer (figure 17).
3 Front Plastic Housing
Latches (Maytag and
Amana Models Only)
Tabs (Maytag and Amana
Models Only)
Console Assembly
Mounting Screw (1 of 2)
Console Assembly
Mounting Bracket Latches
Figure 17. Remove the console panel to
access the console electronics and housing
assembly.
Whirlpool Models:
3. Gently remove the decorative trim that
surrounds the door and upper console by
unsnapping it from the dryer. See figure 18.
COM Lt. Motor
Blue Black
Red Relay
P9
1
5
Black-White
Tan
White
Green-Yellow
1
Brown
P8
Water Valve Relay
(Steam Models Only)
Console Assembly
Mounting Bracket
Figure 18. Remove the decorative trim.
4. Slide the console up and off of the dryer.
See figure 17.
5. The console mounting bracket is fastened
to the console front panel with two latches at
both sides of the console assembly. Unlatch
the bracket gently with a screwdriver while
pulling the mounting bracket assembly out.
See figure 17.
PAGE 22
Yellow-Red
1
P13
P3
P5
P2
P14
Red
3
Open
1
Black (Gas)
Decorative
Trim
1
8
1
3
1
6
P4
1