Security Menu - Setting The Security Features - Fujitsu LifeBook P3010 Bios Manual

L i f e B o o k P 3 0 1 0 B I O S
SECURITY MENU – SETTING THE SECURITY FEATURES
The Security menu allows you to set up the data security
features of your notebook to fit your operating needs
and to view the current data security configuration. (See
Navigating through the Setup Utility on page 2 for more
information.)
The following tables show the names of the menu fields
for the Security Menu and its submenus, all the options
for each field, the default settings and a description of
the field's function and any special information needed
to help understand the field's use. The default condition
is no passwords required and no write protection.
Remember your passwords! If you set and
forget your User and Master hard disk
passwords, Fujitsu Computer Systems will
not be able to reset it. You may lose data
and have to replace your system board or
hard disk drive.
Info
Supervisor Password Is:
User Password Is:
Drive0 HDD Password Is:
Set Supervisor Password
Set User Password
Set Drive0 HDD Password:
BIOS Password on Boot:
HDD Password on Boot:
F1 Help
ESC Exit
10
Phoenix SecureCore(tm) Setup Utility
System Advanced Security
Clear
Clear
Clear
[Enter]
[Enter]
[Enter]
[Disabled]
[Enabled]
Select Item -/Space
Select Menu Enter
Figure 5. Security Menu
■ Entering a password incorrectly 3 times in
a row causes the keyboard and mouse to
be locked out and the warning [System
Disabled] to be displayed. If this hap-
pens, restart the computer by turning off
and on the power with the power switch
and use the correct password on reboot.
If you make an error when re-entering
■
the password a Warning will display on
the screen. To try again press [Enter],
then retype the password. Press [Esc] to
abort the password setting process.
■ If Security Panel on Resume is Enabled
and the Password on Boot is Disabled
you will not have to type your password
upon resuming the system from the Sus-
pend or Save-to-Disk modes. Power
Management Security will work only if
Password boot is enabled.
Boot Exit
Item Specific Help
Press <Enter> key to
set Supervisor Password
to enable any password
features.
Then password entry is
required to enter BIOS
Setup.
Change Values F9
Select Sub-Menu F10
Setup Defaults
Save and Exit