Security Menu - Setting The Security Features - Fujitsu LifeBook N Series Bios Manual

SECURITY MENU – SETTING THE SECURITY FEATURES
The Security menu allows you to set up the data security
features of your notebook to fit your operating needs
and to view the current data security configuration. (See
Navigating through the Setup Utility on page 2 for more
information.)
The following tables show the names of the menu fields
for the Security Menu and its submenus, all the options
for each field, the default settings and a description of
the field's function and any special information needed
to help understand the field's use. The default condition
is no passwords required and no write protection.
Remember your passwords! If you set
and forget your User and Master hard
disk passwords, Fujitsu Computer
Systems will not be able to reset it. You
may lose data and have to replace your
system board or hard disk drive.
Info System
Supervisor Password Is:
User Password Is:
Set Supervisor Password
Set User Password
Password on Boot:
Hard Disk Security
F1 Help
ESC Exit
Phoenix SecureCore Tiano Setup
Advanced Security
Clear
Clear
[Enter]
[Enter]
[Disabled]
Select Item -/Space
Select Menu Enter
Figure 5. Security Menu
S e c u r i t y M e n u
Entering a password incorrectly 3 times in a

row causes the keyboard and mouse to be
locked out and the warning [System Dis-
abled] to be displayed. If this happens,
restart the computer by turning off and on the
power with the power switch and use the cor-
rect password on reboot.
If you make an error when re-entering the

password a Warning will display on the
screen. To try again press [Enter], then retype
the password. Press [Esc] to abort the pass-
word setting process.
If Security Panel on Resume is Enabled and

the Password on Boot is Disabled you will not
have to type your password upon resuming
the system from the Suspend or Save-to-
Disk modes. Power Management Security
will work only if Password boot is enabled.
Boot
Change Values
Select Sub-Menu
Exit
Item Specific Help
Press <Enter> key to
set Supervisor
Password to enable
any password features.
Then password entry
is required to enter
BIOS Setup.
F9 Setup Defaults
F10 Save and Exit
9