Instaswap - Replace Lead, Shoulder Pads & Waist Belt - Master black provac Operator And Parts Manual

REPLACING THE POWER LEAD, SHOULDER PADS AND WAIST BELT
Removing the power lead:
1. Disconnect the connector plug
from the machine.
Installing the
power lead:
1. Feed approximately
45cm of lead between
back support and lower
body, then connect
plug into the socket.
Removing the shoulder straps:
1. Remove shoulder adjustment
strap from the buckle and loop
on the shoulder pad.
Installing the shoulder straps:
1. Start with the shoulder pad
loop entering the handle area.
Feed pad over the handle and
through the loop.
Removing the waist belt:
1. Manoeuvre the tri-slide to a
verticle position so it can slide out
through the slot.
Installing the waist belt:
1. Manoeuvre the tri-slide to a
vertical position so it can slide
into the slot.
7
InstaSwap
2. Slide lead out between
back support and machine.
Remove from cable restraint.
2. Feed power lead
into cable restraint
leaving approximately
20cm of slack in the
cable at the plug end.
2. Remove shoulder pad from
the handle by feeding the pad
back through the loop end
around the handle.
2. Feed the shoulder
adjustment strap through
the loop and buckle on
the shoulder pad.
2. Push tri-slide out through
the slot.
3.Repeat on other side.
2. Push tri-slide in through
the slot.
3. Repeat on other side.