Page 1
Issue: 2 THE BLACK PROVAC BACK PACK VACUUM CLEANER OPERATOR AND PARTS MANUAL Model: BLACK PROVAC Safety approval No: NSW21128 Serial No:________________ Model No: PROBFT1000 EMC Approval No: N14590 Before using machine: For Safety - Read all safety and operator instructions...
INTRODUCTION IMPORTANT SAFETY INSTRUCTIONS! Your new Provac Backvac Vacuum Cleaner is designed The following information signals potentially dangerous for the professional daily maintenance of carpets and hard conditions to the operator or equipment floors. Your Provac vacuum cleaner has been built with WARNING: To reduce the risk of fire, explosion, quality and reliability in mind.
WARNING: Hazardous Voltage. Shock or electrocution can result. Unplugging machine before servicing IS A MUST. MODIFICATIONS - REPAIRS OR SERVICING Only original parts and accessories are to be used. Failure to adhere to these recommendations could result in machine failure and damage that will not be covered by the appliance warranty.
WARNING: Hazardous Voltage. Shock or MACHINE OPERATION electrocution can result. Unplug machine before servicing. FOR SAFETY: Do not operate machine unless operator manual is read and understood. 2. ASSEMBLY OF MACHINE Cloth filter bag and secondary filter: 1. Fit lid with outlet positioned on the left or right of •...
PROVAC COMFORT FIT PROCEDURE NOTE: CONDUCT THE PRE START CHECK LIST BEFORE BEGINNING THIS PROCEDURE Loosen both shoulder straps to make it easier to fit the back pack. Lift the back pack while sliding one arm through the shoulder harness. Slide the other arm through the second shoulder harness.
InstaSwap REPLACING THE POWER LEAD, SHOULDER PADS AND WAIST BELT 2. Slide lead out between Removing the power lead: back support and machine. 1. Disconnect the connector plug Remove from cable restraint. from the machine. Installing the 2. Feed power lead into cable restraint power lead: leaving approximately...
PROVAC PARTS LIST - PROBFT1000 Lid - incl. locking ring PRO1001 Filter dust Bag PRO1027 Secondary filter PRO1035 Body PRO1026 Exhaust filter - set PRO1014 Motor gasket - flo through PRO1010 Vac motor - 1000W, 2 stage, flo through PRO1039 EMC - RFI capacitor PRO1036 Thermal cut out - NOT SHOWN...
WIRING DIAGRAM BLACK MOTOR THERMAL CAPACITOR RFI CUT OUT BLACK A BROWN N BLUE POWER POWER INLET OUTLET SWITCH SOCKET SOCKET A BROWN N BLUE MAINTENANCE ADVICE WARNING: Always disconnect the plug from the main supply before commencing any cleaning or maintenance of the machine.
DAILY START & FINISH CHECK LIST WARNING: HAZARDOUS VOLTAGE - SHOCK OR ELECTROCUTION CAN RESULT FROM USING MACHINE WITH DAMAGED CORD Check power lead and plug. Replace damaged cord before using machine. Check the dust bag is empty. Clean it if necessary before and after vacuuming.
TROUBLE SHOOTING GUIDE PROBLEM POSSIBLE CAUSE SOLUTION • Machine does not operate Plug loose on machine Push in plug Faulty vacuum motor Contact service centre Faulty power cord Replace power cord Faulty power switch Contact service centre • Poor Vacuuming Performance Blocked hose, wand or floor tool Clean out hose, wand or floor tool Full bag...
4. Damage caused by accident, misuse, negligence, abuse or fire. 5. Any Master Australia Pty Ltd products that have not been repaired by Master Australia Pty Ltd or it's Authorised Service Agents.