Wiring - Panasonic Digital Business System Installation Manual

March 1997

Wiring

1 Install the AC15A card into one of the allowed slots. Refer to Table 8 for details of which slots are
available on each system
2 Insert the wires from the private circuit into the DDK in the following order
3 Press the cover of the DDK connector down to the base until it locks firmly into place.
4 Plug the completed DDK connector into the exchange line port (designated COL) on the MDF,
corresponding to the AC15A card location.
5 The other end of the wires should be connected directly or via an intermediate distribution frame (IDF) to
the private circuit interface equipment.
Panasonic Digital Business System - Installation Manual
TX1 wire into hole 1
TX2 wire into hole 2
RX1 wire into hole 3
RX2 wire into hole 4
Figure 31 - DDK AC15A Wiring
40
Issue 5