Arris Touchstone TM608 Installation Manual page 8

viii
Touchstone® Telephony Release 6 Standard 1.0 December 2008
CAUTION
Risk of explosion
Replacing the battery with an incorrect type, heating a battery above 75°C, or
incinerating a battery, can cause product failure and a risk of fire or battery
explosion. Dispose of used batteries according to the instructions.
The battery used in this device may present a risk of fire or explosion when
heated above 75°C or incinerated. Dispose of used battery promptly. Keep
aw ay from children. Do not dissemble or dispose of in fire.
Do not locate the equipment within 6 feet (1.9m) of a flame or ignition
source (e.g. heat registers, space heaters, fireplaces, etc.).
Do not use product near water (i.e. wet basement, bathtub, sink or near a
swimming pool, etc.), to avoid risk of electrocution.
Do not use the telephone to report a gas leak in the vicinity of the leak.
Av oid using and/or connecting the equipment during an electrical storm, to
avoid risk of electrocution.
Use only the power cord included with the equipment.
Clean the equipment using a dry cloth. Av oid solvents or other chemical
cleaners.
Equipment should be installed near the power outlet and should be easily
accessible.
The shield of the coaxial cable must be connected to earth (grounded) at the
entrance to the building in accordance with applicable national electrical
installation codes. In the U.S., this is required by NFPA 70 (National Electri-
cal Code) Article 820. In the European Union and certain other countries,
CATV installation equipotential bonding requirements are specified in IEC
60728-11, Cable networks for television signals, sound signals and interac-
tive services, Part 11: Safety. This equipment is intended to be installed in
accordance with the requirements of IEC 60728-11 for safe operation.
If the equipment is to be installed in an area serviced by an IT power line net-
work, as is found in many areas of Norway, special attention should be given
that the installation is in accordance with IEC 60728-11, in particular Annex
B and Figure B.4.
In areas of high surge events or poor grounding situations and areas prone to
lightning strikes, additional surge protection may be required (i.e.
PF11VNT3 from American Power Conversion) on the AC, RF, Ethernet and
Phone lines.
When the Telephony Modem is connected to a local computer through an
Ethernet cable, the computer must be properly grounded to the building/resi-
dence AC ground network. All plug in cards within the computer must be
properly installed and grounded to the computer frame per the manufac-
turer's specifications.
About this Document