Download Print this page
Sealey SA793 Instructions
Sealey SA793 Instructions

Sealey SA793 Instructions

Combination air nailer/stapler gun

Advertisement

Quick Links

COMbINATION AIR NAILER/STAPLER GUN
Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these
instructions and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL
REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE
PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL
INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1.
SAFETY INSTRUCTIONS
 WARNING! Ensure Health & Safety, local authority, and general workshop
practice regulations are adhered to when using this equipment.
 WARNING! Disconnect from air supply before refilling, servicing or
performing maintenance.
Maintain the gun in good condition (use an authorised service agent).
Replace or repair damaged parts. Use genuine parts only.
Unauthorised parts may be dangerous and will invalidate the warranty.
Use in suitable clean and tidy work area, free from unrelated materials
and ensure there is adequate lighting.
 WARNING! Always wear approved eye and/or face and hand protection
when operating the gun.
Remove ill fitting clothing. Remove ties, loose jewellery, and contain
and/or tie back long hair.
Wear appropriate protective clothing and keep hands and body clear of
working parts.
Maintain correct balance and footing. Ensure the floor is not slippery and
wear non-slip shoes.
Keep children and unauthorised persons away from the working area.
Check moving parts alignment on a regular basis.
Ensure workpiece is secure before operating the gun. Never hold a workpiece by hand.
When the gun is put down during pauses in operation ensure that the trigger catch slide is not
depressed by the weight of the gun or by placing the gun in a restricted position that could put
pressure on the trigger catch slide.
During extended breaks in operation disconnect the gun from the air supply.
 WARNING! Ensure correct air pressure is maintained and not exceeded. Recommended pressure 60- 100psi.
Keep air hose away from heat, oil and sharp edges. Check air hose for wear before each use and ensure
that all connections are secure.
DO NOT point the discharge outlet at yourself or anyone else. Do not point at animals.
DO NOT use any power source except an air compressor.
DO NOT operate the gun near any flammable substance or on any container that once contained a
flammable substance.
DO NOT use the gun for a task it is not designed to perform.
DO NOT operate gun if any parts are damaged or missing as this may cause failure and/or personal injury.
DO NOT carry the gun by the hose, or yank the hose from the air supply.
DO NOT place the gun close to your face and do not point at other persons or animals.
DO NOT operate gun when you are tired and/or under the influence of alcohol, drugs or intoxicating
medication.
DO NOT carry the gun with your finger on the trigger.
DO NOT direct air from the air hose at yourself or others.
When not in use, disconnect from air supply and store in a safe, dry, childproof location.
 WARNING! The warnings, cautions and instructions discussed in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be understood that common
sense and caution are factors which cannot be built into this product, but must be applied by the
operator.
Original Language Version
INSTRUCTIONS FOR:
MODEL No:
SA793
SA793
Issue: 3 - 27/07/11

Advertisement

loading

Summary of Contents for Sealey SA793

  • Page 1 MODEL No: COMbINATION AIR NAILER/STAPLER GUN Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS.
  • Page 2 To overcome this, connect a leader hose to the gun. A quick change coupling may then be used to connect the leader hose to the air line recoil hose. See fig 2 & 3. fig 2 Original Language Version SA793 Issue: 3 - 27/07/11...
  • Page 3 If the air supply system does not have an oiler then lubricate the air gun daily with a few drops of the air tool oil supplied, dripped into the air inlet before use. (To re-order air tool oil use Sealey part Nos.