Hamilton Beach UltraSteam Instructions Manual page 7

Blast of Steam & Spray
Blast of
Steam
Retractable Cord
1. To use blast of steam, the
Spray
Temperature/Steam Dial must be
set in the steam range.
2. To get a blast of steam, press the
the iron to create the steam. Please
use iron carefully, as steam is hot
and can cause burns or serious
injury.
3. To spray a mist of water, press
(not available on all models)
1. Press and hold the Cord Release
Cord
Button while pulling cord to desired
Release
length. Do not unwind cord beyond
Button
indicator on cord.
2. To store cord, place the iron, sole-
Wind
plate down, on ironing board.
clockwise
Unlatch Retractable Cord Handle
and wind clockwise.
IMPORTANT! Do not press Cord
Release Button while winding cord.
Only wind clockwise or the cord may
jam. See illustration.
3. If cord jams while winding, push the
Cord Release Button to unwind
slightly until cord is free. Then slowly
start to wind clockwise again.
Blast of Steam
Button. Do not
press button con-
tinuously. Press
once every two
seconds. Some
time is needed for
the Spray Button to
dampen wrinkles
that are difficult to
remove.
7