How to Use Your Blood Pressure Monitor ....8 The M3 Manual Inflation Blood Pressure Monitor is intended for home How to Install/Replace the Batteries ......9 use.
IMPORTANT SAFETY NOTES IMPORTANT SAFETY NOTES To assure the correct use of the product basic safety measures should When using batteries, the battery liquid may leak and damage the always be followed including the precautions listed below: main unit. Please observe the following points. Self-diagnosis of measured results and treatment are dangerous.
Operating Instructions KNOW YOUR UNIT KNOW YOUR UNIT Main Unit: Display Components: Storage Case Four “AAA” Alkaline (LR03) Batteries ON/OFF Button Settings Button MEMORY Button Air Connector Battery Compartment Arm Cuff: The arm cuff should last for 18 months, when used four times a day.
HOW TO USE YOUR BLOOD PRESSURE MONITOR HOW TO INSTALL/REPLACE THE BATTERIES 1. Turn the main unit over. 2. Slide the battery cover in the Preparation direction of the arrow while pressing Insert the batteries page 9 the ribbed part of the cover. 3.
HOW TO INSTALL/REPLACE THE BATTERIES HOW TO SET THE DATE AND TIME Battery Life & Replacement Your blood pressure monitor automatically stores up to 21 measurements, and also calculates average values based on the three most recent measurements taken within 10 minutes of the last reading. (If there are only two readings in memory for that period, the average will be based on two readings.
HOW TO SET THE DATE AND TIME HOW TO SIT CORRECTLY WHEN TAKING A MEASUREMENT 4. Repeat steps 2 and 3 to set the month. You can take a measurement on either your left or right arm. The month is set and the day digits flash on the display.
HOW TO SIT CORRECTLY WHEN TAKING A MEASUREMENT HOW TO APPLY THE ARM CUFF NOTES: Be sure to wrap the arm cuff correctly so that you get accurate results. • Correct posture during measurement is necessary to get accurate Measurements can be taken in light clothing. However, please remove results.
HOW TO APPLY THE ARM CUFF HOW TO TAKE A MEASUREMENT 3. Position the arm correctly. 1. Turn on the monitor. 1) The air tube should run down the NOTE: Press the inflation bulb to release any air in the arm cuff. inside of your forearm and be in 1) Press the ON/OFF button to turn the monitor on.
Page 10
HOW TO TAKE A MEASUREMENT HOW TO TAKE A MEASUREMENT 2) When the desired pressure has been achieved, release the inflation bulb. Correct Remain still and do not talk. Posture • The current time continues to be displayed while the cuff is being inflated. Do not talk during the measurement.
Page 11
HOW TO TAKE A MEASUREMENT HOW TO TAKE A MEASUREMENT 4. Measurement ends. 6. Undo the fastener and remove the arm cuff. The deflation symbol flashes on the display. As the arm cuff deflates further 7. Press the ON/OFF button to turn the monitor off. blood pressure and pulse rate values are NOTE: If you forget to turn the monitor off, it will automatically shut displayed.
HOW TO USE THE MEMORY FUNCTION HOW TO USE THE MEMORY FUNCTION This monitor has a memory capable of storing 21 sets of readings. Every 3. Press the MEMORY button again, while time you complete the measurement, the monitor automatically stores the the average reading screen is displayed.
Care and Maintenance HOW TO USE THE MEMORY FUNCTION MAINTENANCE AND STORAGE TO DELETE ALL THE READING MAINTENANCE You cannot delete individual stored readings, all the readings will be To keep your digital blood pressure monitor in the best condition and deleted.
MAINTENANCE AND STORAGE ERROR INDICATORS STORAGE SYMBOL CAUSE CORRECTION Keep the unit in its storage case when not in use. Repeat measurement. Remain Movement during still and do not talk during 1. Unplug the air tube from the air connector. measurement.
Blinks or appears extremely low (or during measurement. measurement. continuously high). Refer to page 19. Contact your OMRON service Clothing is Remove any clothing Device error. interfering with the interfering with the arm representative. arm cuff. cuff. Refer to page 13.
TROUBLESHOOTING TIPS SPECIFICATIONS OMRON Manual Inflation Blood Pressure Monitor Name: PROBLEM CAUSES REMEDY Model: LCD Digital Display Display: The unit loses power The batteries are Replace all four “AAA” Pressure: 0 to 299 mmHg, Pulse: 40-180/min. during measurement worn or have been Measurement Range: batteries with new ones.