Listing And Code Approvals; Appliance Certifi Cation; Btu & Effi Ciency Specifi Cations; Glass Specifi Cations - Quadra-Fire SANTAFE-MBK Owner's Manual

SANTA FE FREESTANDING
1

Listing and Code Approvals

A. Appliance Certifi cation
Model Santa Fe Pellet Stove
Laboratory OMNI Test Laboratories, Inc.
Report No. 061-S-77d-6.2
Type Solid Fuel Room Heater/Pellet Fuel
Burning Type
Standard ASTM E1509-04, ULC S627-00 and
ULC/ORD-C1482-M1990 Room Heater
Pellet Fuel Burning type and (UM)
84-HUD, Mobile Home Approved.
FCC Complies with Part 15 of FCC Rules.
Operation is subject to the following
two conditions: (1) this device may not
cause harmful interference, and (2) this
device must accept any interference
received, including interference that may
cause undesired operation.
NOTICE: This installation must conform with local codes. In
the absence of local codes you must comply with the ASTM
E1509-04, ULC S627-00, (UM) 84-HUD and ULC/ORD-
C-1482.
B. BTU & Effi ciency Specifi cations
EPA Certifi ed:
Effi ciency:
EPA BTU Output:
Heating Capacity:
Vent Size:
Hopper Capacity:
Fuels:
Shipping Weight:
*BTU will vary, depending on the type of fuel you use in your
appliance. Consult your Quadra-Fire dealer for best results.
These heaters meet the US Environmental Protection
Agency's Emission limits for pellet heaters. Under specifi c
conditions the Santa Fe stove has shown to deliver heat at
rates ranging from 8,500 to 28,200 BTU/hr.
Meets EPA particulate matter (smoke) control requirements
for non catalytic wood heaters built on or after July 1,1990.
C. Glass Specifi cations
This stove is equipped with 5mm ceramic glass. Replace
glass only with 5mm ceramic glass. Please contact your
dealer for replacement glass.
6
1.8 grams per hour
78%
8,500 - 28,200 / hr
up to 1,500 sq. ft. depending on
climate zone
3" or 4" L or PL
45 lbs
Wood pellets or Shelled Corn
240 lbs
D. Electrical Rating
115 VAC, 60 Hz, Start 4.1 Amps, Run 1.1 Amps
E. Mobile Home Approved
• This appliance is approved for mobile home installa-
tions when not installed in a sleeping room and when
an outside combustion air inlet is provided.
• The structural integrity of the mobile home fl oor, ceil-
ing, and walls must be maintained.
• The appliance must be properly grounded to the frame
of the mobile home and use only Listed pellet vent
Class "L" or "PL" connector pipe.
• Outside Air Kit, part OAK-ACC must be installed in a
mobile home installation.
Fire Risk.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be voided by,
the following actions:
• Installation and use of any damaged appliance.
• Modifi cation of the appliance.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved by
Hearth & Home Technologies.
• Operating appliance without fully assembling all components.
• Operating appliance without legs attached (if supplied with unit).
• Do NOT Overfi re - If appliance or chimney connector glows,
you are overfi ring.
Any such action that may cause a fi re hazard.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualifi ed
installer, service agency or your dealer.
NOTE: Hearth & Home Technologies, manufacturer of
this appliance, reserves the right to alter its products, their
specifi cations and/or price without notice.
Quadra-Fire is a registered trademark of Hearth & Home
Technologies.
7050-146A
WARNING
6/27/2014