Preparation For Use; Inspection/Check; Storage, Or Shipping; General - Hobart JET-EX 4 Operation And Maintenance Manual

SECTION 2. PREPARATION FOR USE, STORAGE, OR SHIPPING

1. Preparation for Use

A. General
The generator set is shipped with a dry battery and an empty fuel tank. After the battery is filled with
electrolyte and charged, the fuel tank filled and the generator set inspected, the generator set is ready
for use.
CAUTION: READ OPERATING INSTRUCTIONS IN SECTION 1-3 BEFORE OPERATING THE
UNIT.
B. Inspection/Check
Inspect the unit completely prior to operation.
(1) Remove crating, blocking, banding, ties, and other securing and protective material. After shipping
carton is removed, remove the four carton supports from the bases of the clearance lights. Then in-
stall the attached clearance light lenses in their bases.
(2) Inspect exterior for shipping damage such as broken glass, damaged sheet metal, etc.
(3) Open canopy door and inspect interior for foreign material such as rags, tools, shipping papers,
etc.
(4) Check fuel, coolant, and oil hoses and connections for visible leaks. If leaks are discovered, cor-
rect by tightening hose clamps, tube fittings, etc., as required.
(5) Check security of attaching and retaining hardware.
(6) Check the following for sufficient quantity.
(a) Fuel
Fuel tank capacity is 21 gallons (79.5 liters). Use no lead gasoline.
(b) Engine coolant
The radiator cap is located above the front canopy. Coolant level should be approximately
one inch below the filler neck. Allow a sufficient capacity for coolant expansion.
CAUTION: BE SURE THE COOLING SYSTEM ANTIFREEZE SOLUTION IS ADEQUATE TO PRO-
TECT BELOW LOWEST TEMPERATURE EXPECTED.
(c) Engine lubricating oil
The oil level dipstick is located on the left side of the engine. Refer to Ford Maintenance and
Operator's Manual for oil recommendations.
May 20/89
OM-2049
1-2
Page 1