Monitor; Cd/Tape A In/Out; Cd/Tape B Input - Mackie tt24 Owner's Manual

Mackie TT24 Digital Live Console Owner's Manual
4.1.6

MONITOR

These ¼ - in TRS output connectors provide three balanced line - level signals
that can be used to provide another stereo (L, R outputs) or mono (M output)
main mix output or to monitor the CD/TAPE A or CD/TAPE B inputs. See
MONITOR SOURCE
Connect these outputs to the inputs of an amplifier, powered speaker, or re-
cording device. Typically, the L and R outputs are connected to active studio
monitors and the M output to an active floor wedge.
4.1.7

CD/TAPE A IN/OUT

These RCA jacks connect to the inputs and outputs of a CD/tape device. The
TAPE IN jacks accept an unbalanced signal from a tape recorder or other signal
source using standard consumer audio RCA cables. The signal can be routed to
the MONITOR outputs with CD/TAPE A selected as the source in the MON.
SOURCE Touchscreen (see page 94). This allows cueing intermission music
through the MONITOR or PHONES outputs.
The CD/TAPE A inputs can also be routed to the MAINS OUT from the STEREO
INPUT Touchscreen. This allows playing music between sets over the main PA
speakers. When engaged, the QuickMix Area provides input level adjustment
for CD/TAPE A on a rotary encoder.
WARNING: Selecting L/R in the STEREO INPUT Touchscreen for the CD/TAPE A input can cre-
The CD/TAPE A outputs produce an unbalanced signal that is tapped off the
MAINS OUT. Normally, these are connected to the inputs of a recorder, but
they can be used as two additional main outputs (i.e., for another zone).
4.1.8

CD/TAPE B Input

These ¼ - in TRS input connectors accept balanced or unbalanced line level
signals from the outputs of a CD/tape player or virtually any stereo line - level
source.
The CD/TAPE B input can be routed to the MAINS OUT from the STEREO
INPUT Touchscreen (see page 95). This allows adding the signal to the MAINS
OUT or just playing music between sets over the main PA speakers.
on page 94 for more information.
ate a feedback path between TAPE IN and TAPE OUT. Make sure your tape
deck is not in record, record pause, or input monitor mode, and turn the tape
level control all the way down.
46
Rear Panel Connectors